How to pair PILCEV lamp control with myQ Smart Garage Hub?

  • 1
  • Question
  • Updated 9 months ago
I have a new myQ Smart Garage Hub which I have programmed to monitor the garage door status.  (It won't control my old Wayne Dalton Quantum 303 Mhz garage door opener.)  I also have a myQ Remote Lamp Control model PILCEV that I've tried to pair with the myQ hub but the instructions say to follow the steps in the MyQ app by going to the HOME screen.  My app doesn't give me a HOME screen, just the Device Management screen which shows my garage door under the Hubs section.  Nothing seems to take me to any HOME screen.  What am I doing wrong?
Photo of Willard Volquardsen

Willard Volquardsen

  • 16 Posts
  • 3 Reply Likes

Posted 9 months ago

  • 1
Photo of MyQ Community Manager

MyQ Community Manager, Employee

  • 2294 Posts
  • 139 Reply Likes
Willard, to program your lamp control with the MyQ app, go to the MyQ app's main screen. There should be a plus sign in the upper right corner. Click that. This will take you to a screen that directs you to add the device, which will be lamp control. Let us know if that helps or if you need further assistance. Thanks, Chuck
Photo of Willard Volquardsen

Willard Volquardsen

  • 16 Posts
  • 3 Reply Likes
Thanks Chuck,  I don't know what I did wrong before but following your instructions got me to the screen where I was able to add my lamp controller.   I've been wowing my wife by turning the lamp on and off from my cell phone.
Photo of MyQ Community Manager

MyQ Community Manager, Employee

  • 2294 Posts
  • 139 Reply Likes
Willard, that's so great to hear! Thanks, Chuck